Connector (Bonding Agent)

A bonding agent providing adhesion between the natural nail or tip and the product. You might think of it as a “two-sided sticky tape”. Connector is to be applied in a very thin layer; it should not be shiny and the texture of the nail plate should still be visible. Connector never penetrates into the natural nail or damages the nail surface.

Available in 7ml, 15ml, 50ml & 100ml

Modeling Resin (Builder)

Building gel that adds strength and durability and can be sculptured as well as over tips or overlays. Recommended; two medium-thickness applications for new sets (not one very thick coat, which would generate more heat). Three or more thinner applications may be used for very sensitive clients or those with damaged nails.

Available in Pink, Cool Pink, Soft Pink and Clear in 7ml, 15ml, 50ml & 100ml.

French Modeling Resin (White Builder)
Natural French Modeling (Natural White Builder)
Ultra White Fill (French Back Fills)

Used to extend the free edge to create a “French Manicure” look. French Modeling Resin can be applied onto the natural nail, a tip or a form.
The applied layer should not be too thick. It should not appear as a solid white on the form, but with the grid of the form slightly showing through.
Ultra white fill is extra white pigment used between gel layers.

Available in 7ml, 15ml & 50ml

Sealer (High Gloss Finish)

Used to finish the nail service and provide a very high gloss shine on a scratch resistant surface. Application is to be generous, thicker than connector. Make sure to avoid cuticle contact.

Available in Clear or Natural Pink in 7ml, 15ml, 50ml & 100ml.

One Component (Self Leveling-Lower Viscosity)
Available in Clear or Pink in 7ml, 15ml, 50ml & 100ml.

Active Component (Self Leveling-Higher Viscosity)
Available in Pink, Cool Pink, Soft Pink and Clear in 7ml, 15ml, 50ml & 100ml.

These products may be explained as Connector, Modeling Resin and Sealer combined into one product for versatility and simplicity. One Component enables nail technicians to speed up time. Application must be in three steps 1) Thin, like connector 2) Thicker, for strength 3) Thin again, like sealer. Cure after each coat. This product is best suited for fills, tips, overlays and resin toe applications. It is not designed strictly as a building product, but perfect for clients who have a natural c-curve and/or naturally strong nails.

Back to TopPage [1]--- 2 --- 3 --- 4 --- 5next